How to established up a thermal printer

Eradicate the product or service from its packaging. Eradicate all tape and tabs from the lid, entrance and again then open up the paper tray. Open the interior entry door, and then take away the packing materials from the inside of the product or service. Close the interior entry door.Open the paper tray. Pull out the input tray extension.

Hook up the adapter to the product or service, and then hook up the strength cord to the adapter. Hook up the strength cord to an electrical outlet. Do not hook up the USB cable at this time.

Press the strength button ( ) to change on the product or service.

Pull out the input tray extension. Slide the paper-width instruct to its outermost place. Slide the paper-width instruct out. Faucet a stack of paper on its facet and number one or bottom on a flat surface area to align the edges. Test the paper to make definitely sure that it meets the subsequent requirements: make definitely sure that the paper is no cost of rips, dust, wrinkles, and curled or bent edges. make definitely sure that all of the sheets in the stack are the equivalent measurement and style. Insert the stack of paper into the input tray with the small edge first of all and the facet to be printed on going through down. Slide the stack of paper forward right up until it stops. Load the paper into the product or service

CAUTION: Make definitely sure that the product or service is idle and tranquil when loading paper into the input tray. If the product or service is engaged in a task, the paper will probably be pushed in very far forward and cause the product or service to eject blank pages.

Slide the paper-width instruct inward right up until it stops at the edge of the paper. make definitely sure that the stack of paper fits within the input tray and is not larger than the number one of the paper-width instruct.

Press the strength button ( ) to change on the product or service. Open the print cartridge door. The print carriage moves to the far ideal facet of the product or service. If the print carriage does not move to the ideal facet, change the product or service off, and then change it again on. Eradicate the new print cartridge from its packaging, getting careful to contact only the black plastic. Carefully take away the plastic tape utilizing the pink pull tab.

CAUTION: Do not contact the copper-coloured contacts or ink nozzles. Touching these parts can result in clogs, ink failure, and damaging electrical connections.

Slide the new print cartridge at a minor upward angle into the vacant slot, and carefully press it right up until it snaps into site. To install a tri-colour print cartridge, insert it into the still left slot. To install a black print cartridge, insert it into the ideal slot. Close the print cartridge door. The product or service prints a cartridge alignment sheet since it acknowledges that the print cartridges are new. Preserve this sheet to align the print cartridges.

Lift the product or service lid. Site the alignment sheet on the glass so the number one of the sheet is on the ideal facet with the text going through down. Make definitely sure the sheet is aligned with the ideal-entrance corner of the glass. Reduce the product or service lid. Press the scan button ( ) on the product or service regulate panel. The product or service aligns the print cartridges.

Do not hook up the product or service to the computer system with the USB cable right up until prompted to do so by the computer software installation wizard. Insert the HP computer software CD into the computer system. If you do not have or are not able to use the CD, simply click below to down load the HP computer software. The HP computer software installation wizard shows. Carry out the on-display screen instructions to complete the installation.